nmkoza
-
Any good small muffler/resonator options? Wanting to make my dump more quiet. I can angle the dump to the left more and take the acutal "dump" 90 off but will have limited space for a muffler.
Posted by nmkoza@reddit | projectcar | View on Reddit | 16 comments
-
Tips on masking rim for paint? Trying to paint only the inner area and the lines that come out of the inner area. Like 1.5 hour in and don’t like the 1/3 of the wheel I’ve done so far… any tips to make this easier? Testing using a Qtip (with paint) for the lines but not sure I like it
Posted by nmkoza@reddit | projectcar | View on Reddit | 45 comments
-
Turbo kei truck cutting out? when under boost. 660cc motor with a carb, blow through turbo setup. Recently made a post about this and concluded it was a fuel issue. Have a new fuel pump/regulator putting out 6psi of pressure. Turbo puts out roughly 3ish psi. cuts out when fully accelerating
Posted by nmkoza@reddit | projectcar | View on Reddit | 39 comments
-
Follow up turbo Kei truck post. I think I have a bad waste gate actuator. When I add vacuum to the actual the piece that goes to the waste gate valve it doesn’t move at all. Even out of vehicle. Does this confirm I have a bad actuator? Or is there something I don’t understand?
Posted by nmkoza@reddit | projectcar | View on Reddit | 3 comments
-
Turbo Kei truck fuel pressure regulator not working. The truck itself is a carb blow through setup. Pressure regulator has its 2 feeds and return. Has a vacuum line going to the turbo. But the gauge doesn't read anything and when I use the adjuster I don't get more pressure. I've tried 2 regulators
Posted by nmkoza@reddit | projectcar | View on Reddit | 11 comments
-
Turbo Kei truck fuel pressure regulator not working. The truck itself is a carb blow through setup. Pressure regulator has its 2 feeds and drain. Has a vacuum line going to the turbo. But the gauge doesn’t read anything and when I use the adjuster I don’t get more pressure. I’ve tried 2 regulators
Posted by nmkoza@reddit | projectcar | View on Reddit | 0 comments
-
recently turbo kei truck (carb) dies out when full throttle. Only when fully in boost. I am thinking there is more boost pressure than fuel pressure so it is loosing fuel. Does this sound like it is most likely the issue? If so any easier fixes rather than going fuel injected?
Posted by nmkoza@reddit | projectcar | View on Reddit | 26 comments
-
Can anyone confim which is the oil feed and oil drain? I was assuming feed is the first pic and drain is the second pic (because of the way the turbo sits) but want to confim
Posted by nmkoza@reddit | projectcar | View on Reddit | 19 comments
-
Can anyone confim which is the oil feed and oil drain? I was assuming feed is the first pic and drain is the second pic (because of the way the turbo sits) but want to confim
Posted by nmkoza@reddit | projectcar | View on Reddit | 1 comments
-
Turbo questions for kei truck - an fittings
Posted by nmkoza@reddit | projectcar | View on Reddit | 6 comments
-
oil filter sandwich plate quesiton. For a turbo intall I wnana use this plate for my oil feed to the turbo. On the sandwich plate there is the "in" and the "out" from the plate. Im assuming I would use the out for the feed. But then do I just block off the in? Im going to drain directly to the pan
Posted by nmkoza@reddit | projectcar | View on Reddit | 28 comments
-
Planning on putting a turbo on my kei truck, general turbo questions
Posted by nmkoza@reddit | projectcar | View on Reddit | 8 comments