Kyocera MA2600cfx TWAIN scanning issue
Posted by Baz_8755@reddit | sysadmin | View on Reddit | 3 comments
I have been struggling to set up scanning software on my Windows 11 PC with my MA2600cfx.
I have installed the 3.3.0216 TWAIN driver and pointed it at the IP address of the printer.
I have tried the Kyocera scanning software without success and tried Paint Shop Pro, this had a little success as it did manage to get an image off the scanner but then goes crazy by seemingly receiving the same image over and over until I kill the process.
I have also tried setting things up with WIA without success but ideally would like to use TWAIN across my network.
Any advice/experience/suggestions/guidance etc would be much appreciated.
rejectionhotlin3@reddit
Seems like every windows update either kicks TWAIN out or ESCL for us. We have to bounce back and forth depending on what's affected.
Civil_Inspection579@reddit
Honestly the fact that Paint Shop Pro successfully receives one image suggests the network/TWAIN connection itself is probably working, but the session termination or page-handling handshake is breaking afterward. That “same image repeatedly until killed” behavior usually points more toward driver/protocol incompatibility than pure connectivity failure.
BCIT_Richard@reddit
At work we install TWAIN & ISIS as every department has decided on a different process, so this covers the bases, maybe you'll have better luck with ISIS, though I understand the desire to use TWAIN