3d Menendez magazine failure
Posted by Lazy_Honey6823@reddit | GunnitRust | View on Reddit | 10 comments
When I get to round 15 the magazine keeps cracking along the magazine release noth,what should I do
Atticus_710@reddit
Look up @DannyMeatball on the sea for alternative mags. Standing by for the down votesā¦..
internetpizza@reddit
you're right tho, DMB mags are better
rudevocab@reddit
That's very interesting you say it only cracks at round 15 š¤ I'm gonna take a wild guess and say your settings aren't configured to the best option. I can see those lines on your print as well
Antique-Echidna-1600@reddit
Print lines equal bad print
Lazy_Honey6823@reddit (OP)
Ok,I did this z banding square test and one side was smooth but on the other 3 you could see lines
Lazy_Honey6823@reddit (OP)
Do you think this is a mechanical or slicer issue,maybe moisture in filament?what do you think?
Lazy_Honey6823@reddit (OP)
I only see the lines on the mag,like last night I printed a receiver for an smg and all those lines were really not there,or maybe since the receiver was much bigger the lines where less noticeableĀ
Antique-Echidna-1600@reddit
I would do 0.6 steel with 0.16mm layers and use a filament dryer.
Shit_On_Wheels@reddit
Your settings. There's underextrusion all over the place.
Go print some random non-gun related object and post it to /r/fixmyprint
Lazy_Honey6823@reddit (OP)
I mean the other things I am printing so.t look to bad but maybe I am wrong.since they are all bigger parts that makes the inconsistenciesĀ harder to identify.but I really don't see the same outcome on the other parts like I see on the mag