Bosch Update 120nm

Posted by kayadruid@reddit | ebikes | View on Reddit | 13 comments

Hey Guys ,

I Install newest Bosch Update for 120nm gen5 Motor .

But No Option for 120nm in Software.

Anyone got Same Problem?

[-]

Alecascarano15@reddit

I had to delete app and reinstalled for it to show .

[-]

AccomplishedAd9371@reddit

nach 24 Std. und 37 Minuten habe ich auch 120 Nm.

[-]

AccomplishedAd9371@reddit

Seit gestern KTM mit CX BDU3840 Softwareversion 19.54.0. Max. Leistung ist 750 W aber immer noch nur max. 100 Nm?

[-]

UKtraindriver@reddit

Same here.

Flow app is updated to date (1.35.5)

Update to phone was fine, then install to bike was fine.

Got the BDU384 motor which is compatible.

I got 600% assist but don’t have the 120nm

[-]

TIL_TED@reddit

Which exact version does your Flow app show is installed? If 05/2026, you can see the following in the release notes:

Please note: After you have updated your eBike, it can take up to 24 hours until the blue “New performance value for your drive unit” banner becomes available.

[-]

Latest one is actually 19.54.0, make sure your flow app is fully up to date too. Still, even with everything at latest version, it could take up to 24h for the torque slider to show new value, for some reason

[-]

kayadruid@reddit (OP)

Got it allrdy Show Up i installed and Nothing Show Up after correct Finish

[-]

kayadruid@reddit (OP)

Over the Air Update lol Sure free for all , you Not Up to Date Mate