Hi,

So i bought a coswheel r19 a few months ago. Built quality looks good and its great to drive and has good torque and speed. The only issue after driving up a mountain 2 times the motor already burned out. Reason is that they put way to much power i to the motor. Its stated 3000w continous 6000w peak. In reality its 100A / 8000w all the time.

Support was not helpful about how to reduce the max amprage. They did ship a replacement motor tough but even tough we agreed on it beeing shipped already assembled it came nake no tiire to sproket. ( needs special tool in extra long version to change the sproket)

The controller seems to be a lingbo controller model lbmc-h260-m11-r73-V0.3

Has anyone had any luck connecting lingbo software to it via uart? I found 4 pins that where closed of and they also have the matching voltages 3x 3.3v 1x gnd

I have already found that one pin with battery voltage is needed to wake the controller up. It also starts to flash. But i dont get any uart output on any of these ports also i dont know the right bausrate but testes everyone. Also tried putty but still no output. Any help would be highly apreciated.