I see you

Posted by Snakedoctor404@reddit | projectcar | View on Reddit | 8 comments

Been missing for a couple years. Hiding between the frame and oil pan on a G body. Taking bets on what it is...🤣🤣

[-]

disappointed_sausage@reddit

Pretty sure that's my 10mm. I've been looking EVERYWHERE for it .

[-]

HeroMachineMan@reddit

Yeah? was that the 10mm which I lent you 3 months back?😛

[-]

jcsosew@reddit

my guess it;s a cheap 13 mm socket never found a lost snap on

[-]

dscottj@reddit

Listening to a fastener as it goes bouncing into the deep crevasses of my car is possibly one of sounds I hate the most. Especially if I don't hear it bouncing off the floor shortly after.

[-]

I was tightening down a hose clamp for the heater core on the very back of the motor and dropped the entire wrench and didn’t hear it hit the floor. Fucker was on top of the bell housing and I had to lift the car to get it.

[-]

disappointed_sausage@reddit

I dropped a rocker nut down the head of a big Chevy one time. Couldn't pull the oil pan with the engine in the truck (88 S10) but I could get it to drop about 4", just enough to get my hands in. I pawed around in that oil pan for an hour. No nut. I finally put a wrech on the crank bolt and turned it a little, "clunk" into the bottom of the pan. Goddamn thing was sitting on a rod or somewhere on the crank journal. Took me most of a day to work a new, one piece pan gasket into it and bolt the pan back up. Pretty sure that was after I took the intake off because i thought it might have been in the lifter valley. 1 star, would not recommend.

[-]

Far_Kangaroo2550@reddit

1/4 socket. Maybe 3/8 or 5/16?