DIY Nameless 37mm Breachface?
Posted by Downloading_Bungee@reddit | GunnitRust | View on Reddit | 7 comments
I bought a balls kit from inmc but never got around to building it. I got a great deal on a bambu A1 and have been looking to jump back in, however I would like to start with an easier launcher. Wondering if anyone has found a way to make or buy a metal breach face?
Festiva3D@reddit
Send cut send has the metal ones. It should be in the file pack. I printed a breech for mine and it has held up well so don’t write off just printing one. Can always swap out to the metal one later on
Downloading_Bungee@reddit (OP)
Thanks ill give that a shot.
Festiva3D@reddit
It is quite a fun build. I’m going to mount one under my nylaug once I get it finished.
Downloading_Bungee@reddit (OP)
Another question I had, where did you source the barrel from? The one from the balls kit is too small externally.
Festiva3D@reddit
I honestly bought a whole fence post from Lowes 🤣. I built a few of them and had a few buddies built some too so we made use of it haha
Downloading_Bungee@reddit (OP)
Did you have to use some sort of bushing or did it fit tight in the barrel mount?
Festiva3D@reddit
It was a tighter fit. I epoxied my barrel in